JVC TM-1051DG - Manual (Page 7)

7
6 Audio output terminals (E. AUDIO MONITOR
OUT)
Decodes EMBEDDED AUDIO signals and outputs
them as analogue signals.
• See the table below for the combinations of the
audio channels from the CH1 or CH2 terminal.
Audio output modes
1ch
2ch
3ch
4ch
5ch
6ch
7ch
8ch
1–2ch
3–4ch
5–6ch
7–8ch
1–4ch
5–8ch
AUTO
Audio output terminals
CH1 CH2
channel 1 channel 2
channel 2 channel 2
channel 3 channel 4
channel 4 channel 4
channel 5 channel 6
channel 6 channel 6
channel 7 channel 8
channel 8 channel 8
channels 1+2 channels 1+2
channels 3+4 channels 3+4
channels 5+6 channels 5+6
channels 7+8 channels 7+8
channels 1–4 channels 1–4
channels 5–8 channels 5–8
all channels all channels
About the audio output level
• When several audio channels are output at the same
time, the more channels that are selected, the lower
each channel’s output level will be. (Each channel’s
output level becomes half for “1–2ch,” quarter for
“1–4ch.”)
• The “AUTO” setting mixes and outputs all channels the
signal has. The output level is automatically set
according to the number of channels.
NOTES:
• When you change the input to INPUT A or B, the audio
signals and channels of INPUT C or D selected last
time are output from these terminals.
• The audio signal is output from these terminals only
when the monitor is turned on.
To select the audio channel:
Using the MENU control, you can select the audio
channel output from the audio output terminal.
☞ “4 MENU control” on page 4
• Set the group of the audio output modes you want to
select beforehand.
☞ “E. AUDIO GROUP” on page 14
7 E. AUDIO SDI terminals (IN C, IN D)
Accepts the following signals.
• SMPTE259M SD SDI signal
• EMBEDDED AUDIO signals including up to 8 audio
channels with the sampling frequency of 48 kHz.
About the AUDIO LEVEL METER function
You can check the conditions of the current EMBEDDED
AUDIO signals on the AUDIO LEVEL METER display.
You can turn on/off the AUDIO LEVEL METER display or
change its setting using SET-UP MENU.
☞ “STATUS DISPLAY” on pages 16 and 17
8 SWITCHED OUT terminal
Outputs the re-clocked signals.
• The input signal (INPUT C or D) currently selected
is output from this terminal.
NOTES:
• When you change the input to INPUT A or B, the signal
of INPUT C or D selected last time is output from this
terminal.
• The signal is output from this terminal only when the
monitor is turned on.
6 7 8
EN02_LCT1993-001A-f.p65 06.1.5, 18:25 7