JVC HR-J455EA - Manual (Page 18)

18
EN
TIMER RECORDING
G-
CODE
Setup
Turn on the TV and select the VIDEO channel (or AV mode).
Guide Program Number Set
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS INITIAL SET
SCREEN
2
Press PUSH JOG %fi to place the pointer next to
"INITIAL SET", then press OK or PUSH JOG .
ACCESS G-CODE SET-UP
3
Press PUSH JOG %fi to place the pointer next to
"G-CODE SET-UP", then press OK or PUSH JOG .
ENTER GUIDE PROG
NUMBER
4
Press PUSH JOG %fi or
NUMBER keys to enter the
Guide Program number for
the desired station as shown
in the TV listings. Then
press OK or PUSH JOG .
%
%
%
The G- CODE timer programming system eliminates the need to
input channel, date, start and stop time data when setting the
timer record function. Simply key in the G-
CODE number for the
TV programme you wish to record (found in most TV listings)
and the recorder’s timer is automatically programmed.
You have to set "GUIDE PROG" numbers, which are assigned to
each station for purposes of G-
CODE timer programming, for all the
stations stored in your recorder's memory to get proper results.
Before G- CODE setup you must have performed the following
procedures:
● Tuner setting ( ੬
pg. 6, 28)
● Clock setting ( ੬
pg. 8)
IMPORTANT
Perform the following procedure after Auto Set Up on page 6
and/or the channel setting steps on pages 28 – 31.
After setting the Guide Program Numbers, channel positions
may be incorrect if you stored or skipped channels. In this case,
re-perform Guide Program Number setting.
1 2 3
4 5 6
7 8 9
0
2
4
1
3
NUMBER
PUSH JOG
MENU
OK
G-CODE SET-UP
GUIDE PROG TV PROG
2 5
[0-9] OR [ 5/∞] : SELECT =
[MENU] : EXIT