Sony TCW-E475 - Manual (Page 14)

14
Dubbing a tape
You can copy a tape in deck A to a tape in deck
B at normal or high speed.
1
Load a recorded cassette into deck A
and a blank cassette into deck B.
Make sure the record-protect tabs on the
cassette in deck B have not been removed.
2
Select the side(s) to be recorded on.
To record on Set DIRECTION MODE to
One side g
Both sides s.
Recording on the reverse side
on deck B starts
independently of playback on
deck A.
RELAY.
Recording on the reverse side
on deck B starts
simultaneously with playback
of the reverse side on deck A.
3
Select the dubbing speed.
To select Press HIGH/NORMAL
Normal speed Once
High speed Twice
“HIGH” or “NORM” appears in the
display.
The deck changes to dubbing standby.
4
Select the side from which to start
dubbing.
To record from Press
The front side H
The reverse side h
5
Press X PAUSE on deck B to start
dubbing.
To stop dubbing
During Press
Normal-speed dubbing x on deck B
High-speed dubbing x on either deck
Tips
• During high-speed dubbing, only x is operative.
• Dubbing is automatically performed with the same
recording level and Dolby NR as the original in
deck A. You don‘t have to adjust the recording
level or select the Dolby NR during dubbing. If,
however, you want to monitor the sound during
normal-speed dubbing, set the DOLBY NR selector
to match the tape in deck A (see page 7).
• You can adjust the pitch of the playback on deck A.
See page 7.
Note
If a TV set is placed near the tape deck, noise may
occur during high-speed dubbing. In that case, turn
the television set off or move it away from the tape
deck.
Dubbing only specific
portions
You can do this only during the normal-speed
dubbing.
1
Press x on deck A at the portion you
want to skip.
Deck B changes to recording pause.
2
Locate the point you want to resume
recording on deck A, then stop the
tape.
3
Press X PAUSE on deck B to resume
dubbing.