Sony TCW-E475 - Manual (Page 7)

7
Playing a Tape
Playing a Tape
Playing a tape
1
Turn on the amplifier and select the
tape deck position.
2
Press POWER, and press A fully to
open the cassette holder, then load a
cassette.
3
Set DIRECTION MODE.
To play back Set to
One side only g
Both sides continuously 1) s
Both decks in succession 1) RELAY
1) The deck automatically stops after playing back
five times.
4
Press H .
The deck starts playing. Adjust the volume
on the amplifier.
Do not press POWER or A while the
tape deck is operating. If you do so,
the tape may be damaged.
To Press
With the side you
want to play
facing you
Stop playing x
Start playback from the
reverse side h
Pause X PAUSE. Press the button
again to resume play.
Fast-forward or rewind M or m when the deck
is stopped
Take out the cassette A after stopping playing
Tips
• Push in PITCH CONTROL to activate the Pitch
Control function and turn the control clockwise to
raise the pitch or counterclockwise to lower it.
You can adjust the pitch during playback on deck A
or normal-speed dubbing (but not during RMS
play
2) or RMS dubbing 2) ).
2) TC-WE675 only
• To play a tape recorded with the Dolby 3) NR, set
DOLBY NR to ON (TC-WE675 only) and select
the same position that the tape was recorded in—B
or C.
3) “Dolby”, “HX Pro”, and the double-D symbol are
trademarks of Dolby Laboratories.