Woodstock STEELEX ST1000 - Manual (Page 12)

-10- ST1000 14" Bandsaw
Figure 7. Carriage bolts in rear holes.
Components and Hardware Needed: Qty
Carriage Bolts M8-1.25 x 16 ............................................34
Hex Nuts M8-1.25 ...............................................................34
Base Plate ................................................................................ 1
Legs ........................................................................................... 4
Side Leg Braces ..................................................................... 2
Front/Rear Leg Braces ......................................................... 2
Support Braces ...................................................................... 2
To assemble the stand:
1. Place the base plate upside down on a flat
surface, and loosely attach the legs to the base
plate with the carriage bolts and hex nuts.
Note: Install the carriage bolts with the round end
facing out.
2. Loosely attach the front/rear leg braces and side
braces to the legs, then turn the stand right side
up. Make sure it sits level, then tighten all the
hex nuts.
3. Place the support braces on the underside of
the base plate, making sure the hole patterns
match and are properly aligned.
4. Insert a carriage bolt through two end holes in
each brace and loosely secure them as shown in
Figure 7.
Assembling Stand
Components and Hardware Needed: Qty
Body Assembly ...................................................................... 1
Hex Bolts M8-1.25 x 35 ....................................................... 4
Hex Nuts M8-1.25 ................................................................. 4
Flat Washers 8mm ................................................................ 4
Lock Washers 8mm .............................................................. 4
Main Body
The Model ST1000 is a
heavy machine (154 lbs.).
DO NOT over-exert yourself
while unpacking or moving
your machine—get assis-
tance.
To install the main body:
1. With the help of an assistant, set the body onto
the stand and align the stand holes with the
main body.
2. Have your assistant hold the main body in place
and secure the main body to the stand (Figure
8 ) with the hex bolts, flat washers, lock washers,
and hex nuts.
Figure 8. Securing main body to the stand.