Woodstock STEELEX ST1000 - Manual (Page 15)

ST1000 14" Bandsaw -13-
Installing Positive
Stop
Components and Hardware Needed: Qty
Hex Bolt M8-1.25 x 80 ......................................................... 1
Hex Nut M8-1.25 ................................................................... 1
To install the positive stop:
1. Thread the M8-1.25 hex nut halfway onto the
M8-1.25 x 80 hex bolt (this is the positive stop
bolt).
2. Thread the positive stop bolt into the threaded
hole on the trunnion support bracket as shown
in Figure 16.
Figure 16. Installed positive stop bolt.
Positive Stop
Components and Hardware Needed: Qty
Trunnion Support Bracket ................................................. 1
Table .......................................................................................... 1
Hex Bolts M8-1.25 x 30 ....................................................... 2
Lock Washers 8mm .............................................................. 2
Knobs M10-1.5 ...................................................................... 2
To install the table:
1. Align the trunnion support bracket with the
pins and bolt holes in the body (Figure 15).
Table
Figure 15. Aligning trunnion support bracket with
the pins and bolt holes.
2. Secure the trunnion support bracket with the
hex bolts and lock washers.
3. Remove the table pin and table insert.
4. With the blade in the table slot, move the table
over the base, rotate the table, and place the
table bolts through the trunnions.
5. Thread the knobs onto the table bolts to secure
the table.
6. Re-install the table pin and table insert.