Woodstock STEELEX ST1000 - Manual (Page 16)

-14- ST1000 14" Bandsaw
Components and Hardware Needed: Qty
Fence Body ............................................................................. 1
Front Angled Rail .................................................................. 1
Front Square Rail .................................................................. 1
Rear Rail ................................................................................... 1
Hex Bolts M6-1 x 10 ............................................................. 4
Hex Bolts M6-1 x 20 ............................................................. 4
Lock Washers 6mm .............................................................. 7
Flat Washers 6mm ................................................................ 7
Knob M10-1.5 x 25 ............................................................... 1
To install the fence:
1. Secure the rear rail against the rear of the table
with the flat un-drilled surface facing up, and
install two M6-1 x 20 hex bolts flat washers and
lock washers.
2. Attach the front angled rail to the front of the
table with M6-1 x 20 hex bolts, flat washers, and
lock washers.
3. Attach the square rail to the front angled rail
with the M6-1 x 10 hex bolts, lock washers and
flat washers (Figure 17).
Installing Fence
Figure 17. Installing front rail system.
Figure 18. Correctly installed fence.
4. Set the fence on the fence rail to the left of the
blade.
5. Secure the fence with the M10-1.5 x 25 knob
(Figure 18).