Sennheiser EK 2000 - Manual (Page 31)

30
Synchronizing a transmitter with the receiver
Synchronizing a transmitter with the
receiver
Upon delivery, transmitter and diversity receiver are synchronized with
each other. If, however, you cannot establish a transmission link between
transmitter and diversity receiver, you have to synchronize the channels of
the devices:
̈
Deactivate the RF signal on all transmitters (see the instruction manual
of the transmitter).
This prevents that, during the frequency scan, the channels used by
switched-on transmitters are displayed as “used”.
̈
With a diversity receiver, perform a frequency preset scan to scan the
frequency banks for unused channels (“
Scan New List ”, see page 23).
̈
Select a frequency bank and a channel on this diversity receiver
(“
Current List ”, see page 22).
If you want to set up a multi-channel system, select a frequency bank
with a sufficient number of unused channels for all planned transmis-
sion links.
Via the “ Sync Settings ” submenu, you can set additional transmitter
parameters directly on the diversity receiver and activate or deactivate
the transfer of these parameters to the transmitter (see page 28).
̈
Synchronize a transmitter with the diversity receiver (see page 19).
The receiver’s frequency, name, pilot tone setting and, where applies,
additional parameters activated via the “
Sync Settings ” submenu are
transferred to the transmitter.
When synchronizing a transmitter with a diversity receiver, please
observe the following:
̈
Only use a transmitter and a diversity receiver from the same
frequency range (see the type plates on the transmitter and
the diversity receiver).
̈
Make sure that the desired frequencies are listed in the
enclosed frequency information sheet.
You can also contact your Sennheiser partner who will be
pleased to calculate intermodulation-free frequencies for you.
̈
Make sure that the desired frequencies are approved and legal
in your country and, if necessary, apply for an operating
license.