Care, Contact with liquid, Questions and answers – Siemens Gigaset S45 User Manual

Page 19: Appendix, Care contact with liquid questions and answers

Advertising

Appendix

Gigaset S45 / en / A31008-M1754-R101-1-6Z19 / start_guide_time.fm / 02.09.2005

Appendix

Care

Wipe the charging cradle and the hand-

set with a damp cloth (do not use sol-

vent) or an antistatic cloth.

Never use a dry cloth. This can cause

static.

Contact with liquid

If the handset has come into contact with

liquid:
1. Switch the handset off and remove

the batteries immediately.

2. Allow the liquid to drain from the hand-

set.

3. Pat all parts dry, then place the handset

with the battery compartment open

and the keypad facing down in a dry,

warm place for at least 72 hours (not

in a microwave, oven etc.).

4. Do not switch on the handset again

until it is completely dry.

When it has fully dried out, you will nor-

mally be able to use it again.

Questions and answers

If you have any queries about the use of

your telephone, you can contact us at any

time at www.siemens.com/gigasetcus-

tomercare . The table below contains a list

of common problems and possible solu-

tions.

The display is blank.
1. The handset is not switched on.

Press and hold the end call key

2. The batteries are flat.

Charge or replace the batteries (page 4).

The handset does not respond to a key press.
The keypad lock is activated.

Press and hold the hash key

(page 8).

"Base station x" is flashing in the display.
1. The handset is outside the range of the base

station.

Reduce the distance between handset/

base station.

2. The handset has been de-registered.

Base Search is flashing in the display.
Handset is set for

Best Base

and no base station

is within range.

Reduce the distance between handset/base

station.

Handset does not ring.
The ringtone is switched off.

Activate the ringtone (page 16).

The other party cannot hear you.
You have pressed the

(INT) key. The hand-

set is "muted".

Switch on the microphone again (page 8).

You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.

Repeat the operation.
Watch the display and refer to the operating

instructions if necessary.

Advertising