Siemens Gigaset S45 - Manual (Page 6)

5
First Steps
Gigaset S45 / en / A31008-M1754-R101-1-6Z19 / start_guide_time.fm / 02.09.2005
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the lugs on the belt clip
click into the notches.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Slide your finger nail or a screw driver
down the notch to separate the belt
clip from the cover. Push the entire
cover upwards so that it unclicks.
Registering your phone
Before you can use your Gigaset S45 you
must register it to a base station. It can be
registered to a maximum of four base sta-
tions. The actual registration procedure
will depend on the type of base station.
Automatic registration Gigaset S45 to
Gigaset S450/S455
Important: The handset must not already
be registered to any base station.
Registering the handset to the Gigaset
S450 base station occurs automatically.
¤
Place the handset in the base with its
display facing forward.
Registration takes around 1 minute. Dur-
ing this process, Regstr.Procedure appears
in the display and the name of the base
station flashes e.g. Base 1 . When the
handset has registered, its screen displays
its internal number, e.g. INT 2 for internal
number 2. The handset is assigned the
lowest available internal number (1-6). If
all internal numbers 1-6 have been
assigned, number 6 is overwritten, pro-
vided the handset with the internal
number 6 is in idle status.
Manual registration Gigaset S45
If the handset does not switch on auto-
matically when the batteries are fitted,
you must first charge the batteries.
You must activate manual registration of
the handset at both the handset and the
base station.
After it has registered, the handset returns
to idle status. The handset's internal
number is shown in the display e.g. INT 1 .
If not, repeat the procedure.
Notes:
– Automatic registration is not possible when
the base station on which you wish to reg-
ister the handset is being used to make a
call.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work,
you will have to register the handset manu-
ally.