Sanyo PLV-55WM1 - Manual (Page 3)

3
To the Owner
CAUTION : TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE EXCEPT LAMP REPLACEMENT.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
THIS SYMBOL INDICATES THAT DANGEROUS
VOLTAGE CONSTITUTING A RISK OF ELECTRIC
SHOCK IS PRESENT WITHIN THIS UNIT.
THIS SYMBOL INDICATES THAT THERE ARE
IMPORTANT OPERATING AND MAINTENANCE
INSTRUCTIONS IN THE OWNER'S MANUAL WITH
THIS UNIT.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Before operating this LCD Projection Monitor, read this
manual thoroughly and operate the LCD Projection Monitor
properly.
This LCD Projection Monitor provides many convenient
features and functions. Operating the LCD Projection Monitor
properly enables you to manage those features and maintains
it in better condition for a considerable time.
Improper operation may result in not only shortening the
product-life, but also malfunctions, fire hazard, or other
accidents.
If your LCD Projection Monitor seems to operate improperly,
read this manual again, check operations and cable
connections and try the solutions in the “Troubleshooting”
section in the end of this booklet. If the problem still persists,
contact the dealer where you purchased the LCD Projection
Monitor or the service center.
Safety Precaution
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
– Install the LCD Projection Monitor in a proper position. If
not, it may result in a fire hazard.
– Provide appropriate space on the top, sides and rear of the
LCD Projection Monitor cabinet for allowing air circulation
and cooling the LCD Projection Monitor. Minimum
clearance must be maintained. If the LCD Projection
Monitor is to be built into a compartment or similarly
enclosed, the minimum distances must be maintained. Do
not cover the ventilation slot on the LCD Projection
Monitor. Heat build-up can reduce the service life of your
LCD Projection Monitor, and can also be dangerous.
– Do not put any flammable object or spray can near the LCD
Projection Monitor, hot air is exhausted from the ventilation
holes.
– If the LCD Projection Monitor is not to be used for an
extended time, unplug the LCD Projection Monitor from
the power outlet.
READ AND KEEP THIS OWNER'S MANUAL FOR LATER
USE.
Care for Using the LCD Projection Monitor
When using the LCD Projection Monitor, the following
precautions should be taken. Otherwise, the screen can be
damaged:
● Do not push or hit the screen surface.
● Do not write, paint or affix anything on the screen.
● Do not put anything on the LCD Projection Monitor.
For cleaning the LCD Projection Monitor, refer to "Cleaning the
LCD Projection Monitor" on p46 and maintain it properly.
NOTE:
●
Black dots or bright points of light (red, green, or blue) may appear on the
screen. This is a characteristic of the LCD panels, not a malfunction of the
LCD Projection Monitor.
Do not push or hit
the screen.
Installing the LCD Projection Monitor Safely
When installing the LCD Projection Monitor, secure the
Projection Monitor on the wall with safety parts (included)
with hook and a chain or wire. If not, the LCD Projection
Monitor may fall down and accident can result.
Holder
Screw
Secure with a chain
or wire (not supplied)
Screw
hole
Attach the holder on
the back of the LCD
Projection Monitor
with a screw. Then
secure the holder
on the wall with a
commercially avail-
able chain or wire
and a hook.
Attaching the
safety parts
Hook
Chain, wire and hook
must sustain load of
33 lb (15kg).
Chain and wire
should be stretched
tight.
Chain or Wire