Sanyo PLV-55WM1 - Manual (Page 33)

33
Input Source Selection (INPUT 1 / PC digital, AV HDCP)
Direct Operation
Select INPUT 1 by pressing the INPUT 1 button on the remote control
or pressing the INPUT button on the front panel arbitrary number of
times.
Before using these buttons, correct input source should be selected
through menu operation as described below.
See p16-17 for the connection diagrams.
Select the Input Menu with the Point Up / Down button, and
then press the Point Right button to enter the sub-menu.
Select INPUT 1 with the Point Up / Down button and then press
the SELECT button or the Point Right button. The Source
Selection Menu will appear.
1
2
Move the pointer to the source that you want to select and then
press the SELECT button. 3
Menu Operation
Input Menu
Source Selection Menu
Close the Source Selection
Menu.
pointer
Computer Input
NOTE:
●
HDCP (High-bandwidth Digital Content Protection) is a system for protecting digital
entertainment content delivered by DVI (Digital Visual Interface) from being copied.
The specification of HDCP is decided and controlled by Digital Content Protection, LLC.
Should the specification be changed, this LCD Projection Monitor may not display the
digital content protected by HDCP.
INPUT 2
INPUT 1
FREEZE
VOLUME
+
MUTE
AUDIO-S
SURROUND
INPUT 3
INPUT 4
INPUT 5
Remote Control
INPUT 1 button
Computer Input
INPUT 1
INPUT 2
INPUT button Front Panel
INPUT button
INPUT
MENU SELECT 7
VO –AUDIO–R
INPUT 3
INPUT 4
INPUT 5