Sanyo PLV-55WM1 - Manual (Page 7)

7
Installing the LCD Projection Monitor
Openings on the cabinet are provided for ventilation, to
ensure reliable operation of the product and to protect it
from overheating. Therefore, these openings must not be
blocked or covered.
CAUTION
Hot air is exhausted from the exhaust vent. When using
or installing the LCD Projection Monitor, the following
precautions should be taken.
– Do not put any flammable objects near the vent.
– Keep the exhaust vent at least 0.3’(10cm) away from
any objects.
– Do not touch the peripheral part of the exhaust vent,
especially screws and metallic parts. These areas will
become hot while the LCD Projection Monitor is being
used.
Cooling fans are provided to cool down the LCD Projection
Monitor. This LCD Projection Monitor monitors internal
temperature and control the running speed of the cooling
fans.
Air Circulation
Installation
CAUTION
Never touch the Projection Screen directly with a hand.
It may effect the projection image quality.
Placing and Settling the LCD Projection Monitor
BE SURE TO USE OR PLACE THE LCD PROJECTION
MONITOR IN THE TEMPERATURE INDICATED
BELOW:
CAUTION
When placing the LCD Projection Monitor, the spaces for
ventilation must be maintained.
Place the LCD Projection Monitor on flat places or with an
exclusive LCD Projection Monitor stand. Placing on unflat
places may cause picture tilt or distortion.
Do not place the LCD Projection Monitor under the direct
sunlight. This may have a damaging effect on the picture
quality and the screen surface of the LCD Projection
Monitor.
41 ˚F ~ 95 ˚F (5 ˚C ~ 35 ˚C)
14 ˚F ~ 140 ˚F (-10˚C ~ 60 ˚C)
Operating Temperature
Storage Temperature
0.3'
(10cm)
0.6'
(20cm)
0.3'
(10cm)
Exhaust Vent
(Hot air exhaust)
Exhaust Vent
(Hot air exhaust)
0.6'
(20cm)
0.6'
(20cm)