Sharp XG-P25X - Manual (Page 34)

E-31
Operation Buttons
Selecting the Input Signal Source
Using the Operation Buttons
Press INPUT 1.2.3 or INPUT 4.5 on the projector or
INPUT (1, 2, 3, 4 or 5) on the remote control to change
the mode.
• When no signal is received, “NO SIGNAL” will be displayed.
When a signal that the projector is not preset to receive is
received, “NOT REG.” will be displayed.
INPUT 1 Mode INPUT 2 Mode INPUT 3 Mode
INPUT 4 Mode INPUT 5 Mode
On-screen Display
Projector Remote control
INPUT
Adjusting the Volume
Press VOLUME ؁/؀ to adjust the volume.
On-screen Display
Projector Remote control
Muting the Sound
Press MUTE to temporarily turn off the sound.
Press MUTE again to turn the sound back on. Projector
On-screen Display
Remote control
MUTE
VOLUME
XG-P25X/CD (E)-c 02.3.19, 7:06 PM 31