Sharp XG-P25X - Manual (Page 58)

E-55
Basic Operation
Protecting Important Settings with a Password
A password can be set by the user and used with the keylock level to prevent adjustments to certain
settings on the GUI. See page
38 for the procedure details.
• When password is set, you need to enter the password to use “PRJ Mode”, “Stack Setting”, “Keylock Level”, “Set Inputs”,
“RS-232C” and “Set ID No.” menus.
Setting the Password
1 Enter the new password using ∂/ƒ to select the desired number, and then press © to select the next digit.
Continue this procedure for the remaining three digits, and then press ENTER.
2
Enter the password again (“Reconfirm”) using ∂/ƒ/ß/©, and then press ENTER.
• After setting the password, be sure to write it down in a secure location in case you can not remember it.
Changing the Password
1
Enter the old password using ∂/ƒ/ß/©, and then press ENTER.
2
Enter the new password using ∂/ƒ/ß/©, and then press ENTER.
3
Enter the password again (“Reconfirm”) using ∂/ƒ/ß/©, and then press ENTER.
XG-P25X/CD (E)-e 02.3.19, 7:11 PM 55