Sharp XG-P25X - Manual (Page 66)

E-63
Maintenance & Tr
oubleshooting
Replacing the Lamp
10 Attach the lamp cage
cover.
Slide the lamp cage cover in
the direction of the arrow. Then
tighten the user service screw.
User service screw
9 Insert the new lamp cage.
Press the lamp cage firmly into
the lamp cage compartment.
Fasten the securing screws.
8 Remove the lamp
cage.
Remove the securing screws
from the lamp cage. Hold the
lamp cage by the handle and
pull it towards you.
1 Connect the power
cord. Reset the lamp timer.
While pressing ƒ, © and
ENTER on the projector, press
POWER ON on the projector. Plug the power cord into the AC
socket of the projector.
Resetting the lamp timer
“LAMP 0000H” is displayed,
indicating that the lamp timer is
reset.
2
• Reset the lamp timer only after replacing the lamp.
Ł
Securing
screw
Securing
screws
7 Remove the lamp cage
cover.
Turn over the projector and
loosen the user service screw
that secures the lamp cage
cover. Then slide the cover in
the direction of the arrow.
User service screw
6 5 Replace the air filter. Replace the filter
cover.
Insert the tab on the end of the
filter cover into the filter cover
opening and press the filter
cover into position. Place the air filter underneath the
tabs on the filter frame.
Tab
XG-P25X/CD (E)-g 02.3.19, 7:12 PM 63