Sharp XG-P25X - Manual (Page 53)

E-50
Basic Operation
These functions allow you to reduce the power consumption when the projector is in standby mode.
See page
38 for the procedure details.
Power Save Function
Function to control the quantity of projected light. Select “Low Power Mode” or “Standard Mode” to decrease or
increase brightness and power consumption.
Selecting the Economy Mode
Quantity of light is 80%.
Power consumption is 330W.
Quantity of light is 100%.
Power consumption is 380W.
• “Power Save” mode is factory preset to “(Standard Mode)”.
• When selecting “ (Standard Mode)” in “Power Save Mode”, fan noise increases.
• Even when selecting “ (Low Power Mode)” in “Power Save Mode”, fan noise may increase if internal temperature rises
enough to activate the cooling function.
Monitor Out/RS-232C Off Function
This projector consumes power when using a monitor connected to the OUTPUT port for INPUT 1, 2 and a
computer connected to the RS-232C port. When not using these ports, “MNTR Out/RS232C” can be set to “
” to
reduce standby power consumption.
• “MNTR Out/RS232C” is factory preset to “ ”, and “Auto Power Off” is factory preset to “ ”.
Standby power for Monitor Out/RS-232C
connection turned off.
Monitor Out/RS-232C on
CAUTION
• Set “MNTR Out/RS232C” to “ ” when using the Sharp Advanced Presentation Software (supplied).
Automatic Power Shutoff Function
When no input signal is detected for more than 15 minutes, the projector will automatically shut off. The on-screen
message, “Power OFF in 5 min.” will appear five minutes before the power is automatically turned off.
Power automatically shuts off after about 15
minutes of no signal input.
Automatic Power Shutoff disabled.
XG-P25X/CD (E)-d 02.3.19, 7:08 PM 50