Sony UP-DR100 User Manual
Page 5
Int
ro
duc
tion
Part Names and Functions
5
A ALARM indicator (25)
Lights in green when the system is initialized, or in
red when an error, such as a paper jam, occurs.
B Information Display (14, 18, 25)
Displays the number of pages printed, or the
amount of paper and ink ribbon remaining.
Messages are displayed when an error or warning
condition occurs.
C Operation panel door
Pull the top edge to open the operation panel door.
Operation panel with door open
A
EXEC Button
Press this button to print the gray scale adjustment
pattern.
B
MENU Button (18)
Press to display the number of pages printed or the
amount of paper and ink ribbon remaining.
Pressing the MENU button changes the printer to
the off-line mode and turns the ONLINE indicator
off.
C
Cursor Buttons (18)
Press these buttons to select the item to be
displayed on the information display.
D
CALIBRATION button (16)
Press this button to adjust the gray balance.
D Maintenance door (22)
Open the maintenance door for cleaning the surface
of the paper. The roller used for removing the dust
accumulated on the surface of the paper is attached
to the door.
Lights in green when the printer is controlled only
by the computer in the on-line mode.
This indicator goes off when the printer goes off-
line, for example, when you press the MENU
button to display the number of pages printed or the
amount of paper and ribbon remaining.
F PRINT Indicator (14)
Lights in green while printing.
G Ventilation holes (22)
Behind the ventilation holes panel, there is a built-
in fan to prevent the thermal head from overheating
Press and hold this button for more than one
second immediately after you replace the paper
and ink ribbon in use. Several sheets of blank
paper are then fed through. In this way, soiled paper
at the beginning of the roll will be eliminated, and
paper improperly loaded at an angle will be
straightened in the paper path. Also, pressing the
FEED button for more than one second during
printing results in cancelling the number of
printings set and clearing the images stored in the
memory. The printer stops printing when the page
currently printing is completed and ejected.
I !POWER switch (14)
Press this switch to turn the printer on or off.
J Paper scrap tray (6)
A margin of about 10mm is put between the current
printout and the next printout from the paper roll.
This margin of paper is cut off and ejected into the
paper scrap tray.
K Paper Output Slot
Printed pages are output from the printer here.
L SCSI Connectors (50-pin, half pitch) (7, 8)
Connect the computer used to control the printer
and connect other SCSI devices with SCSI cables to
one of these connectors. The second connector is
used as a pass-through connector when daisy
chaining with other SCSI devices. If only one of the
SCSI connectors on the printer is used, the internal
terminator should be enabled by changing the
appropriate DIP switch setting, see “DIP Switch
Settings” (page 7).
Determines the SCSI device ID number of the
printer, and sets the internal terminator on or off.
See “DIP Switch Settings” (page 7).
N - AC IN (Power Source) Connector (8)
Connect the supplied power cord here.