SMC Networks TigerCard 1000 - Manual (Page 15)

1-6
I
NSTALLING THE
N
ETWORK
C
ARD
Inserting the Network Card
WARNINGS:
• Network cards are sensitive to static electricity. To protect the
card, avoid touching its electrical components and always touch
the metal chassis of your computer before handling the card.
• Backup your SuperDisk driver diskette and use the copy as the
working diskette to protect the original from accidental
damage.
1. Switch off the computer, unplug the power cord, and remove
the computer’s cover.
2. Select an available 32-bit or 64-bit bus-mastering PCI slot and
remove the cover bracket.
• Use a 64-bit PCI slot if your PC supports this standard.
• If using a 32-bit PCI slot, the end of the card’s edge
connector will be exposed. Be careful that it does not touch
any conducting parts on the PC motherboard.
Note: Some PC motherboard designs may not provide
adequate space behind all 32-bit PCI slots to properly
install the network card.
3. Install the network card into the slot so that it is firmly seated.
Then, screw the card’s bracket securely into the PC’s chassis.