SMC Networks TigerCard 1000 - Manual (Page 17)

1-8
I
NSTALLING THE
N
ETWORK
C
ARD
PCI Configuration
In most cases, your network card is automatically configured when
you power-up your computer. In certain computers, however, you
must modify PCI settings by running your computer’s BIOS Setup
program. For more information, refer to “PCI Compatibility” on
page A-2.
Connection Guidelines
To connect to a 1000BASE-SX Gigabit Ethernet device, use the
SC connector on the network card and 62.5/125 or 50/125 micron
multimode fiber optic cable. Note that for 62.5/125 micron cable
with ST connectors, SMC provides an optional SC to ST plug
converter (SC-ST Converter, P/N 99-012034-091).
The attached device must be within the distance limitations
specified by the IEEE 802.3z 1000BASE-SX specification. Observe
the following guidelines for 1000BASE-SX operation:
K The maximum length of a fiber segment is 270 meters for
62.5/125 micron cable and 550 meters for 50/125 micron
cable. For additional information on cable lengths, refer to
Appendix B.
K For 1000 Mbps operation, the TigerCard 1000 card must be
connected to a 1000BASE-SX compliant switch or buffered
repeater.