Sony RM-AV2000T - Manual (Page 10)

9 EN
5
If you want to set a code for
another component, repeat Steps
3 and 4.
6
Press COMMANDER OFF.
Notes
• If you press a component code number that is
not on the table in the supplied “Component
Code Numbers”, the Commander beeps and
“NG” flashes after you press the ENTER key.
If this happens,check the component code
number, and try setting again.
• If you don’t input anything into the
Commander for over two minutes between
each step, the setup procedure will be
canceled. To set the code, you must again
press
¤ while pressing COMMANDER OFF.
To check which code number is
set
Press the DISPLAY key. The code
number and “ENTER” appear twice.
COMMANDER
OFF
Checking if the code number
works
1
Press the corresponding
Component Select button for the
component you have set up.
The Commander turns on and the
touch-keys appear on the display.
2
Power on the component with its
power switch.
3
Aim the Commander at the
component and press the
u key
in the touch-key display.
When the remote control signal is
sent,
is displayed on the display.
The component should power off.
TV
u
Continued
TV
1 2 3
4 5 6
7 8
0
9
-/--
1-
RED
YELLOW TELETEXT
BLUE
INPUT
u
GREEN TV