Sony RM-AV2000T - Manual (Page 19)

18 EN
Executing a Series of
Commands
— System Control Function
With the System Control function, you
can program a series of operating
commands, and execute them by
pressing just one button.
For example, when you watch a video, a
series of operations like the ones below
are necessary.
Example:
1 Power on the TV.
2 Power on the video (VCR 1).
3 Power on the amplifier.
4 Set the imput selector of the amplifier
to VIDEO 1.
5 Set the input mode of the TV to
VIDEO.
6 Start video playback.
You can program up to 16 consecutive
operation steps to each of the SYSTEM
CONTROL 1, 2 or 3. At the factory,
SYSTEM CONTROL 1 and 2 are not
programmed yet, but a series of Power-
on Commands for Sony Components is
programmed on the SYSTEM CONTROL
3 button.
1
While pressing COMMANDER
OFF, press
Á + and Á –.
You hear a beep and the volume
control setting of visual components
(TV, VCR1, 2 and 3, SAT/CBL, and
DVD) changes to the displayed
component.
Notes
• If you have already programmed the Á or
¤ button of each component any signals by
“learning”, the procedure above will not
change the function of the
Á and ¤ buttons.
• If you have programmed volume control
signals on Á or ¤ buttons of TV or AMP by
the “learning” function (page 12), you can
only use that signal when you select TV or
AMP. For other component, the preset
volume control signals for TV or AMP
(depending on the above setting procedure)
will be transmitted. To use the new signals,
you need to program each button for each
component by the learning procedure
(page 12).
Controlling the Volume of Visual
Components Connected to an
Audio System (continued)
COMMANDER
OFF
+ +
+
–
Á
V + V –
MU
AMP
NG
When set to
amplifier volume
When set to
TV volume
TV
AMP
V
+
V
–
MU
V
+
V
–
MU