Sharp VIEWCAMZ VL-Z5E - Manual (Page 39)

Basic Operations
29
O T H E R S 1
E X E C U T E
O N
O N
O F F
– +
B E E P
R EMO T E
D E F A U L T
PH O N E S V O L
D EMO MO D E
R E T U RN
– + P HO N E S V O L
Using Earphones
(Commercially
Available, VL-Z5 only)
Available modes:
Tape Playback, Tape Camera
You can monitor the sound via stereo
earphones (commercially available) during
playback or recording. Stereo earphones
with a 3.5 mm diameter plug can be used
with this camcorder.
Connect the plug of stereo earphones to the
earphones jack on the camcorder as shown
below.
Notes:
• Before connecting stereo earphones, turn the
camcorder volume down to the lowest
setting.
• The built-in speaker automatically turns off
when stereo earphones are connected to the
earphones jack.
Adjusting the Phones
Volume (VL-Z5 only)
Available mode:
Tape Camera
You can adjust the phones volume if sound
through the earphones is difficult to hear.
1
Set the Media Selection switch to V,
then hold down the Lock button and
set the Power switch to v (see page
21).
2
Press the DISPLAY button until the
mode screen appears (see page 31).
3
Press l or m on the Operation
button to select “MENU”, then press
the centre of the Operation button.
4
Press l or m to select “EXECUTE”,
then press the centre of the Opera-
tion button.
5
Press l or m to select Z, then
press the centre of the Operation
button.
Note: “PHONES VOL” does not appear
with VL-Z3.
6
Press l or m to select “PHONES
VOL” , then press the centre of the
Operation button.
7
Press j or k to adjust to the desired
volume level, then press the centre of
the Operation button.
8
Press the DISPLAY button to turn off
the menu screen.
Earphones jack
(VL-Z5 only)
Decrease Increase