Sundance Spas 680 - Manual (Page 22)

Page 16
680 SERIES
7.0 Spa Fill Up Procedure
FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRETY BEFORE
PROCEEDINg WITH THAT STEP.
1. Prepare The Spa For Filling
• Clear all debris from the spa. (Although the spa shell has
been polished at the factory, you may want to treat it with a
specially formulated spa cleaner.) Consult your authorized
Sundance dealer for additional information prior to filling spa.
• Remove filter/skimmer lid (page 22), then remove filter
cartridge as outlined in Section 11.1 (page 30).
2. Fill Spa
• Place the end of your garden hose into the empty filter bucket.
CAUTION: Never fill with water from a water softener. If your
water is extremely “hard”, it is preferable to fill half-way with
hard water and the rest of the way with softened water. Or,
you may fill entirely with hard water if you use a special water
additive available from your authorized Sundance dealer.
!
• Fill spa with clean tap water from garden hose until water covers
all jets (DO NOT OVERFILL!).
IMPORTANT: Always fill your spa through the filter bucket
after draining. Failure to do so may cause air to be trapped
in either pump, preventing the pump from circulating water.
Remove the hose and replace the filter cartridge. Note: DO
NOT overtighten filter cartridge, finger tight only!
!
3. Turn On Power
Turn on power to spa at the home’s circuit breaker to start boot up
sequence (Section 9.0, page 23). The heater and filter pump will
automatically activate after several seconds. If the control panel LED
flashes water temperature and “COOL” or “ICE” this is normal, refer
to page 37 for additional information.
4. Activate Jets Pumps
Turn on all jet(s) pumps to ensure proper mixing when
adding start-up chemical in step 5.
1 2