Sundance Spas 680 - Manual (Page 38)

Page 32
680 SERIES
WARNINg! READ THIS BEFORE DRAININg: To prevent
damage to the spa’s components, turn off power to the spa
at the circuit breaker before draining it. Do not turn the
power back on until your spa has been refilled.
CAUTION: There are certain precautions to keep in mind
when draining your spa. If it is extremely cold, and the spa is
outdoors, freezing could occur in the lines or the equipment
(see “WINTERIZING”, page 33). On the other hand, if it is hot
outdoors, do not leave the spa’s surface exposed to direct
sunlight.
!
!
To drain your spa, perform the following steps:
1. Turn off power to spa at breaker.
2. Locate and remove the synthetic cabinet door
screws and door. The door is located directly
below the control panel and is easily identified
by it’s vertical cooling slots.
3. Locate drain hose line attached to 2 x 4 wood
slat (Figure A) with tie wraps.
4. Cut tie wraps and pull drain hose from
equipment area (Figure B).
5. Hold drain hose above water line (Figure B),
then unthread drain cap (1) from hose using
a counterclockwise rotation. Place hose on
ground making sure to direct water away from
spa.
6. Turn valve (2) clockwise to open drain (Figure
C).
7. After spa has completely drained, reinstall
drain cap on drain valve finger tight! DO
NOT OVERTIGHTEN! Close valve by turning
clockwise to off position.
8. Place drain hose back inside the spa
equipment bay.
9. Reinstall synthetic cabinet door and screws.
10. After refilling spa, turn on power and follow the “Spa Fill Up
Procedure” (page 16).
11.3 Pillow Care (All Models Except Denali)
Remove and clean the headrest pillows as needed with soapy water
using a cloth or soft-bristle brush. To maintain water resistance and
Figure A
1
2
Figure B
Figure C