Sony RDR-HXD1065 - Manual (Page 153)

153
Addi
tiona
l I
n
fo
rm
at
io
n
, If the HDMI OUT jack is used for video
output, changing the “HDMI Resolution”
setting of “Video Output” in the “Video”
setup may solve the problem (page 140).
Connect the TV and the recorder using a
video jack other than the HDMI OUT, and
switch the TV’s input to the connected
video input so that you can see the on-
screen displays. Change the “HDMI
Resolution” setting of “Video Output” in
the “Video” setup, and switch the TV’s
input back to HDMI. If the picture still does
not appear, repeat the steps and try other
options.
, The recorder is connected to an input device
that is not HDCP compliant (page 19).
, Depending on the setting combination for
“TV Type” and “4:3 Output,” the edge of
the screen may be hidden or displayed with
black bands, or the left and right sides of the
image may flicker. In this case, change the
settings on your TV, not on this recorder.
Depending on the connected equipment,
the video signals of the selected HDMI
resolution may not be output.
, When connecting the DVI equipment,
720×480/576p video signals are output
even when an option other than 720×480/
576p is selected.
, When connecting the DVI equipment and a
PC monitor that is HDCP compliant, only
720×480/576p video signals may be output.
TV programme reception does not fill the
screen.
, Set the channel manually in “Programme
Setting” in the “Basic” setup (page 131).
, Select the correct source using the INPUT
SELECT button, or select a channel of any
TV programme using the PROG +/–
buttons.
The picture is breaking up.
, The signal strength is low.
, Check aerial installation.
TV programme pictures are distorted.
, Reorient the TV aerial.
, Adjust the picture (see the TV’s instruction
manual).
, Place the recorder and TV farther apart.
, Place the TV and any bunched aerial cables
farther apart.
, The aerial cable is connected to the
AERIAL OUT jack on the recorder.
Connect the cable to the AERIAL IN jack.
TV channels cannot be changed.
, The channel is disabled (page 132).
, A timer recording started, which changed
the channels.
, The channel is hidden (page 137).
, The Parental Lock is activated (page 136).
The picture from equipment connected to
the recorder’s input jack does not appear
on the screen.
, If the equipment is connected to the LINE 1
– TV jack, select “L1” in the front panel
display by pressing PROG +/–* or INPUT
SELECT.
If the equipment is connected to the LINE 2
IN jacks, select “L2” in the front panel
display by pressing PROG +/–* or INPUT
SELECT.
If the equipment is connected to the LINE
3/DECODER jack, select “L3” in the front
panel display by pressing PROG +/–* or
INPUT SELECT.
If the equipment is connected to the DV IN
jack, (this is usually for a digital video
camera connection), select “DV” in the
front panel display by pressing INPUT
SELECT.
*Analogue Mode only
The playback picture or TV programme
from the equipment connected through the
recorder is distorted.
, If the playback picture output from a DVD
player, VCR, or tuner goes through your
recorder before reaching your TV, the copy-
protection signal applied to some
programmes could affect picture quality.
Disconnect the playback equipment in
question and connect it directly to your TV.
The picture does not fill the screen.
, Set “TV Type” of the “Video Output” in the
“Video” setup in accordance with the
screen size of your TV (page 140).
,continued