Sony RDR-HXD1065 - Manual (Page 27)

27
H
ook
up
s and
Se
tti
n
gs
Step 6: Easy Setup
Make the basic adjustments by following the
on-screen instructions in “Easy Setup.”
Be careful not to disconnect the cables or exit
the “Easy Setup” function during this
procedure.
1
Turn on the recorder and your TV.
Then switch the input selector on your
TV so that the signal from the recorder
appears on your TV screen.
The initial settings message appears.
• If this message does not appear, select
“Easy Setup” from “SETUP” in the
System Menu (page 151).
2
Press ENTER.
Follow the on-screen instructions to
make the following settings.
Easy Setup - Analogue or Digital Mode
Select either “Digital” or “Analogue”
Mode.
• Select “Digital” if the aerial cable is
connected to DIGITAL AERIAL IN
(hookup A).
• Select “Analogue” if the aerial cable is
connected to ANALOG AERIAL IN
(hookup B or C).
• You can select either Mode if the aerial
cable is connected to both DIGITAL
AERIAL IN and ANALOG AERIAL
IN.
For details, see page 14.
The recorder turns off and then turns on
automatically if you change Mode.
Easy Setup - Postal Code (Analogue
Mode only)
Enter your postal code using the number
buttons or
</M/m/,, and press
ENTER.
To erase a number, move the cursor to
the number, and press O RETURN.
Easy Setup - Auto Tune (Digital Mode
only)
The recorder will automatically capture
and store the available TV and Radio
channels.
Easy Setup - Auto Tuner Preset
(Analogue Mode only)
The programme position order will be
set.
To set the programme positions
manually, see page 131.
Easy Setup - Clock
The recorder will automatically search
for a clock signal. If a clock signal cannot
be found, set the clock manually using
</M/m/,, and press ENTER.
Easy Setup - TV Type (page 140)
If you have a wide-screen TV, select
“16:9.” If you have a standard TV, select
either “4:3 Letter Box” (shrink to fit) or
“4:3 Pan Scan” (stretch to fit). This will
determine how “wide-screen” images are
displayed on your TV.
Easy Setup - Component Out
If you are using the COMPONENT
VIDEO OUT jack, select “On.”
</M/m/,,
ENTER
[/1
O RETURN
TV [/1
Number
buttons
GUIDE
,continued