Chapter 2 connections, Connecting the antenna cable, Method1: antenna + dvd-vcr + tv: no cable box – Samsung V6700 User Manual
Page 13
ENG-
13
C h a p t e r 2
C
O N N E C T I O N S
Connecting the
Antenna Cable
There are several ways to connect your DVD-VCR. Select one of the following antenna connections that best
suits you below.
■
Method 1:
Antenna + DVD-VCR + TV: No Cable box
■
Method 2:
Antenna +Cable box + DVD-VCR + TV: Cable box with many scrambled channels
■
Method 3:
Antenna + DVD-VCR + Cable box +TV: Cable box with a few scrambled channels
- If you are using an off-air antenna that has 300-ohm twin flat leads, use an external
antenna connector (300-75 ohm adaptor: not supplied) to connect the antenna to the
DVD-VCR.
- If you have two separate antennas (one VHF and the other UHF), use a UHF/VHF
combiner-adaptor (available at most electronics shops) to connect the antenna to the
DVD-VCR.
- The RF OUT(TO TV) jack of this product sends signals received through the antenna
and also outputs Audio/Video signals.
Method1:
Antenna + DVD-VCR + TV: No Cable box
Y
ou can record non-scrambled channels by
selecting the channel on the DVD-VCR.
Also use this Method if you watch channels
without cable box.
To RF IN
To RF OUT
Antenna cable
To Antenna Input
000000_V6700_AFS_XAC1 3/8/07 8:44 PM Page 13