Step 5: preparing the remote, Controlling tvs with the remote – Sony RDR-HXD860 User Manual

Page 18

Advertising
background image

C:\2886042111HXD860CEK\01GB-

HXD860CEK\040BAS.fm

master page=left

specdef 20060621

RDR-HXD860

2-886-042-11(1)

18

Step 5: Preparing the
Remote

You can control the recorder using the
supplied remote. Insert two R6 (size AA)
batteries by matching the 3 and # ends on
the batteries to the markings inside the
battery compartment. When using the
remote, point it at the remote sensor

on the

recorder.

b

Notes

• If the supplied remote interferes your other Sony

DVD recorder or player, change the command
mode number for this recorder (page 19).

• Use the batteries correctly to avoid possible

leakage and corrosion. Should leakage occur, do
not touch the liquid with bare hands. Observe the
following:
– Do not use a new battery with an old battery, or

batteries of different manufacturers.

– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an

extended period of time, remove the batteries.

– If battery leakage occurs, wipe out any liquid

inside the battery compartment, and insert new
batteries.

• Do not expose the remote sensor (marked

on

the front panel) to strong light, such as direct
sunlight or a lighting apparatus. The recorder may
not respond to the remote.

• When you replace the batteries of the remote, the

code number and Command Mode may be reset
to the default setting. Set the appropriate code
number and Command Mode again.

You can adjust the remote’s signal to control
your TV.

b

Notes

• Depending on the connected unit, you may not be

able to control your TV with some or all of the
buttons below.

• If you enter a new code number, the code number

previously entered will be erased.

1

Hold down the TV [/1 button located
at the bottom of the remote.

Do not press the [/1 button at the top of
the remote.

2

With the TV [/1 button pressed down,
enter the TV’s manufacturer code
using the number buttons.

For instance, to enter “09,” press “0” then
“9.” After you enter the last number,
release the TV [/1 button.

Controlling TVs with the
remote

Number
buttons

TV t

TV [/1

TV 2 +/–

TV PROG

+/–

TV/DVD

Advertising