Sennheiser SKP 500 - Manual (Page 21)

21
Switching the phantom powering
on/off –
PHANTO
The plug-on transmitter can supply condenser microphones
without internal power supply with 48 V phantom
powering (P 48). The phantom powering can be switched
on or off via the “
PHANTO ” menu. Please note: Dynamic
microphones can be operated in phantom powering mode
without harm. However, if no condenser microphone
module is being used, you should switch off the phantom
powering. With the phantom powering switched on, the
operating time of the batteries or the BA 2015 accupack
will be reduced.
Selecting the standard display – DISLPY
Via the “ DISPLY ” menu, you can select the standard display:
Entering a name – NAME
Via the “ NAME ” menu, you can enter a freely selectable
name for the transmitter. You can, for example, enter the
name of the performer for whom the adjustments have
been made.
The name can be displayed on the standard display and can
consist of up to six characters such as:
y letters (without pronounciation marks),
y numbers from 0 to 9,
y special characters e.g. () - . _ and spaces.
To enter a name, proceed as follows:
̈
Press the SET button to get into the setting mode of the
“ NAME ” menu. The first segment starts flashing on the
display.
̈
With the
̆
/
̄
buttons you can now select a character.
By briefly pressing a button, the display jumps either
forwards or backwards to the next character. If you hold
down a button, the display starts cycling continuously.
Selectable
standard display Contents of standard
display
“FREQ”
“NAME”
“CHAN”