Sony JAX-S8 - Manual (Page 22)

22
En
TIMER OPERATIONS
Sleep timer
Turns off the unit automatically after a specified time.
Press SLEEP on the remote repeatedly.
With each press, the timer duration changes cyclically as
follows:
“AUTO”* “90” “80” - - - “10” “OFF”
The unit turns off after the selected time.
* “AUTO”: The unit turns off when the current CD or tape
finishes the playback (for up to 100 minutes).
Tip:
The display is dimmed while the sleep timer is active.
To check the remaining time until the unit turns off
Press SLEEP on the remote once. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP on the remote repeatedly until “SLEEP OFF”
appears.
Timer playback
Turns on the unit at a specified time every day.
Make sure the clock is set correctly.
Use the remote from step 2.
1 Prepare the source.
To play CD(s), load disc(s).
To play the radio, select the band and tune in to the desired
station or tune in to a preset station (see “Tuning in to
preset stations”).
To play a tape, insert the tape and select the deck.
2 Press VOLUME +, - to set the volume level.
3 Press CLOCK/TIMER/SET to display “DAILY” and
then press ENTER.
“5” indicator lights up and “ON” appears for a moment.
If “SET CLOCK” is displayed, set the clock (see “Setting
the clock”) and carry out from this step again.
4 Press r or t to set the timer-on hour and
then press ENTER.
5 Press r or t to set the timer-on minute
and then press ENTER.
“OFF” appears for a moment.
6 Repeat step 4 and 5 to set the timer-off hour and
minute.
7 Press r or t to select the source (CD,
TAPE and TUNER) and then press ENTER.
8 Press POWER to turn the unit off.
The unit turns on at the specified timer-on time and plays
the selected source and then turns off at the specified
timer-off time.
• To stop timer setting in step 3 to 6, press CLEAR on the
remote.
• The Timer playback will not begin unless the unit is turned
off first.
• Turning VOLUME on the unit is also available in step 2.
• MULTI JOG is also available in place of r or t.
To display the timer setting
Press CLOCK/TIMER/SELECT on the remote, then press r
or t to select “DAILY” and press ENTER. The timer-on
time, the timer-off time and the source are displayed.
To change the timer setting
Re-set the timer again.
To cancel the timer
Press CLOCK/TIMER/SELECT on the remote, then press r
or t to select “OFF” and press ENTER. “5” disappears
from the display.
MULTI JOG
ENTER
Deck B
POWER
VOLUME
CLOCK/TIMER/
SET
CLOCK/TIMER/
SELECT
CLEAR
ENTER
SLEEP
VOLUME
+,–
POWER
STANDBY / ON