Sony NSP-100 - Manual (Page 10)

NSP 100
Op
er
at
io
n
Starting Up and Initial Settings
10
Starting Up and Initial
Settings
When you connect a monitor to the unit, and power on
for the first time, the starting screen appears and it is
then followed by the initial setting screen.
r
When the initial setting screen appears, carry out the
following procedure using the remote controller.
1
With the b and B buttons, select the language you
want to use in the menus, and press the ENTER
button.
This confirms the language selection, and the
“Network Setup” screen appears.
2
Press the ENTER button.
It becomes possible to select whether or not to use
a network.
3
With the b and B buttons, select whether or not to
use a network, then press the ENTER button.
• If you select “No,” the screen changes as follows.
In this case, skip to step 9 .
To return to the previous screen
To return to the previous screen instead of
advancing to step
9 , press the b button.
• If you select “Yes,” next press the ENTER button.
The “Network Setup” screen reappears.
4
Using the v and V buttons, select the item you want
to set, then press the ENTER button.
The setting can now be changed.
5
Using the b and B buttons, select the group to set
within the selected item.
6
Enter the setting with the numeric buttons (0 to 9).
Alternatively, adjust the setting with the v and V
buttons.
For details of the settings to be entered, consult
your system administrator.
7
Press the ENTER button.
This confirms the setting of the selected item.
8
Repeat steps 4 to 7 until all of the required items
have been set.