Sony CDP-XA20ES - Manual (Page 12)

Playing CDs
12 EN
3 Push ➠ AMS ➥ to select the track.
4
Repeat Steps 2 and 3 to program the tracks in the
order you want.
5
Press ✬ to start Program Play.
To cancel Program Play
Press PLAY MODE.
When tracks, which aren’t numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
The program remains even after the Program Play
ends
When you press ✬, you can play the same program
again.
Notes
• The total playing time doesn’t appear in the display when it
exceeds 100 minutes.
• “FULL” appears in the display when you try to add a track
to a program which already contains 24 tracks.
Last programmed
track
Playing order Programmed
tracks
Total playing time
Creating a program using the remote
1 Press PROGRAM before you start playing.
“PROGRAM” appears in the display.
2
Press number buttons of the tracks you want to
program in the order you want.
Example: To program the tracks 2, 8 and 5
Press number buttons in the order 2, 8
and 5.
Last programmed
track
Playing order
To select a track with a number over 10
Use >10 button (see page 9).
If you’ve made a mistake
Press CLEAR, then press the correct track number.
3
Press ß to start Program Play.
To cancel Program Play
Press CONTINUE.
You can check the total playing time while
programming using the remote (Program Edit)
To select a track, press ❁ or ✯ and check the total
playing time. Then press PROGRAM to confirm your
selection.
When tracks, which aren’t numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
The program remains even after the Program Play
ends
When you press ß, you can play the same program
again.
Notes
• The total playing time doesn’t appear in the display when it
exceeds 100 minutes.
• “FULL” appears in the display when you try to add a track
to a program which already contains 24 tracks.
Checking the track order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
track number in the programmed order. After the last
track in the program, the display shows “End” and
returns to the original display. If you check the order
after you start playing, the display shows only the
remaining track numbers.
Total playing time
Programmed
tracks
If you’ve made a mistake
Press CLEAR, then repeat Steps 2 and 3.
2 5
8
A
MIN SEC STEP
PROGRAM
2 5
8
A
MIN SEC STEP
PROGRAM