Sharp PG-M25X - Manual (Page 22)

-22
3
Set each item under “TCP/IP” and “Wireless LAN”.
■ “TCP/IP”
“Obtain an IP address automatically”
Make sure to enable when using the DHCP server function in the projector.
When this function has been selected, the following TCP/IP setting items will
appear gray and no entry is necessary.
“ IP Address ”
Enter the computer’s IP Address.
“ Subnet Mask ”
Enter the subnet mask.
“ Gateway ”
Enter the gateway address.
■ “Wireless LAN”
“Communication Mode”, “ Ch ”
Select the wireless LAN transmission mode and the wireless LAN channel to be
used. When using the projector, make sure to change “Communication Mode”
to “
Peer-to-Peer ”, and the settings on the computer and projector are the same.
“ SS ID ”
Enter the SS ID (Group name).
When the SS ID has been set, make sure to use the same settings on the
projector.
“Encryption ( WEP )”
Select this function to whether or not to encrypt.
(This function is not supported.)
“Wep key”
Enter the encryption key when encrypting.
(This function is not supported.)
4
Click “Save” to register the settings.
The settings will be registered and the dialog box will close.
Click “Cancel” to close the dialog box without registering the settings.