SMC Networks SMC3056EM - Manual (Page 12)

12
3.5 Verifying Your Connection
Start a communication program and place the computer into
terminal mode. Refer to your computer manual to find out the
appropriate command to do so.
Then use the following procedure to verify your installation:
1. Type
AT[Enter]
If your system is operating properly, your EZ
Modem sends an OK response to your screen and
waits for your next command.
2. Use your communication software to prepare your
computer to dial a call. Then type
ATDx phone number[Enter]
where x is equal to T for touch-tone or P for pulse
dialing.
The phone number is your telephone number.
For example, if your EZ Modem is connected to
the telephone line 555-2121 and touch-tone
dialing is supported in your area, type
ATDT 5552121[Enter].
3. You should hear the busy signal and receive a
BUSY response because the EZ Modem is
calling itself.