Sharp AL-1610 - Manual (Page 25)

32
GENERAL INFORMA
TION
User programs
USER PROGRAMS
The user programs allow the parameters of certain functions to be set,
changed, or canceled as desired.
List of user programs
This copier has the following user programs.
Program No. Program name Description
1 Auto clear time Sets the auto clear time. The copier returns to the initial settings
when the auto clear time elapses after the last copy is made.
2 Preheat mode Sets the time that elapses before the copier enters the preheat
mode after any operation is made. See page 34.
3 Auto power shut-off Sets the time that elapses before the copier enters the auto power
timer shut-off mode after any operation is made. See page 34.
5 Auto power shut-off Enables or disables the auto power shut-off mode. See page 34.
setting
21 Paper size setting Sets the copy paper size in the tray.
Setting the user programs
1 Press and hold the light ( ) key for more than 5
seconds until all the alarm indicators ( , , , and
) blink and “– –” appears in the copy quantity display.
2 Enter a program number using the left copy quantity
(
) key.
● The selected program number will blink in the copy quantity display.
● If a mistake is made in steps 2 to 4, press the CLEAR ( ) key. The
copier will return to step 2.
● The program numbers are shown in the table above.
For example, to change the setting of the auto power shut-off timer,
enter 3.
3 Press the START ( ) key.
● The entered program number will be steadily lit on the left side of the
copy quantity display and the currently selected parameter number for
the program will blink on the right side.