Sharp AL-1610 - Manual (Page 26)

33
GENERAL INFORMA
TION
4 Select the desired parameter using the right copy quantity
(
) key.
● The entered parameter number will blink on the right side of the copy
quantity display.
● The parameters are shown in the table below.
For example, to change the setting of the auto power shut-off timer to
60 min., enter 2.
USER PROGRAMS
User programs
Program name Parameters
Auto clear time 0 e OFF 1 e 30 sec. * 2 e 60 sec. 3 e 90 sec. 4 e 120 sec.
5 e 10 sec.
Preheat mode 0 e OFF 1 e 30 sec. 2 e 60 sec. * 3 e 90 sec. 4 e 120 sec.
Auto power shut-off timer * 1 e 30 min. 2 e 60 min. 3 e 90 min. 4 e 120 min. 5 e 240 min.
Auto power shut-off setting 0 e OFF * 1 e ON
Paper size setting 1 e 11"x17" 2 e 8-1/2"x14" * 3 e 8-1/2"x11" 4 e 8-1/2"x11"R
5 e 5-1/2"x8-1/2"
Factory default settings are indicated with an asterisk (*).
If you select “0” (OFF) in a program, the corresponding function will be disabled.
5 Press the START ( ) key.
● The right-hand number in the copy quantity display will be steadily lit
and the entered value will be stored.
6 To continue with other user programs, press the CLEAR
(
) key and then repeat steps 2 to 5. To exit the user
program mode, press the light ( ) key.
● All the alarm indicators will go out.