Sony 2-661-374-11(4) - Manual (Page 32)

32 GB
The tape does not record.
• No tape is loaded. Load a tape.
• The tab has been removed from the tape. Cover
the broken tab with adhesive tape (page 34).
• The tape has reeled to the end.
The system cannot play back the reverse side
of the tape in Deck A or Deck B.
• The system only can play back front side of the
tape in Deck A and Deck B. This is not a
malfunction.
When you press . or > (or press –. or
>+ on the remote), “Not in Use” flashes in
the display.
• The system does not has AMS (Automatic Music
Sensor) function. This is not a malfunction.
The system cannot record the reverse side of
the tape in Deck B.
• The system only can record front side of the tape
in Deck B. This is not a malfunction.
The sound recorded have echo effect.
• Press FLANGER or DELAY repeatedly until
FLANGER and DELAY indicator lights off
before recording start.
If the system still does not
operate properly after performing
the above measures or other
troubles does not described
above occur, reset the system as
follows:
Use buttons on the unit for the operation.
1
Unplug the power cord.
2
Plug the power cord back in.
3
Press ?/1 to turn on the system.
4
Press x, ENTER and ?/1 at the same time.
The system is reset to the factory settings.
You should set the settings you made, such as
the preset stations, clock and timer.
One of the following messages may appear or
flash in the display during operation.
Disc
NO STEP
You have cleared all the steps you programmed.
OVER
You have reached the end of the disc while pressing
M
during playback or pause.
No Disc
There is no disc on the disc tray.
Push STOP!
You have pressed PLAY MODE on the remote
during playback.
Step Full!
You tried to program more than 25 steps.
Reading
The system is reading information of the disc. Some
buttons are not available.
Tape
No Tab
You cannot record the tape because the tab has been
removed from the tape.
No Tape
There is no tape in the tape deck.
Timer
OFF TIME NG!
The on time and off time of Play Timer or Timer
Recording is same.
SET CLOCK!
You pressed CLOCK/TIMER SELECT on the
remote before the clock is set.
SET TIMER!
You pressed CLOCK/TIMER SELECT on the
remote before Play Timer or Timer Recording is set.
PUSH SELECT!
You tried to set the clock or timer during timer
operation.
Others
Not in Use
You have pressed a button those operations is not
allowed or invalid at that time.
Messages