SUPER MICRO Computer X8STI-F - Manual (Page 57)

Chapter 2: Installation
2-33
LSI 1068E
NIC4 LED
JBMC1
SAS Enable/Disable
Jumper Settings
Jumper Settings Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
SAS Enable/Disable (X8STi-3F Only)
JPS1 allows you to enable or disable
SAS Connectors. The default position is
on pins 1 and 2 to enable SAS. See the
table on the right for jumper settings.
SAS RAID Mode Select
Jumper Settings
Settings Definition
Close Software RAID Enabled (Default)
Open IT Mode Enabled
SAS RAID Mode Select (X8STi-3F
Only)
JPS2 allows you to select the SAS RAID
mode. You can use either Software RAID
or IT Mode. Close this jumper to use
Software RAID (Default). Set this jumper
to open to use the IT Mode.
A
B
A. RAID Enable
B. SAS RAID Mode Se-
lect