Troubleshooting check resolución de problemas – Samsung VP-W80 User Manual
Page 58
ENGLISH
ESPAÑOL
58
Troubleshooting Check
Resolución de problemas
Resolución de problemas
✤
Si se encuentra con algún problema al utilizar la videocá-
mara, utilice la siguiente tabla para resolver el problema.
✤
Si las presentes instrucciones no le permiten resolver el
problema tome nota del:
■
Modelo y número de serie marcados en la parte inferior
de la videocámara.
■
Su garantía, si aún estuviera en vigor.
✤
Seguidamente, póngase en contacto con el servicio técnico
autorizado más cercano.
Síntoma
Explicación/Solución
Usted no puede
◆
Verifique la batería (consulte la página 19)
encender la video-.
o el adaptador de corriente AC.
cámara
(consulte la página 18)
Start/Stop no funciona
◆
Verificar los interruptores POWER.
durante la filmación.
◆
Ha llegado al final del videocasete.
◆
Verifique la lengüeta de protección de
grabación del videocasete
(consulte la página 22)
La videocámara
◆
Usted la deja en STANDBY más de
se apaga
5 minutos
automáticamente.
sin utilizarla (consulte la página 24)
◆
La batería está totalmente gastada.
(consulte la página 21)
La batería se gasta
◆
La temperatura atmosférica es
rápidamente.
demasiado baja (consulte la página 21)
◆
La batería no ha sido cargada en su
totalidad. (consulte la página 19)
◆
La batería está totalmente descargada,
y no se puede recargar. Utilice otra
batería.
No puede extraer el
◆
La batería está totalmente descargada.
videocasete
◆
Quizá haya una avería mecánica.
del compartimento.
(consulte la página 57)
El indicador de DATE/
◆
La batería de litio no está instalada o
TIME parpadea más
está totalmente descargada.
de 2 veces cuando
(consulte la página 17)
pasa la videocámara
al modo CAMERA.
Checking
✤
If you run into any problem using the camcorder, use
the following table to try and resolve the problem.
✤
If these instructions do not allow you to solve the
problem, take a note of:
■
The model and serial number marked on the
bottom of the camcorder.
■
Your warranty, if applicable.
✤
Then contact your nearest authorized service centre.
Symptom
Explanation/Solution
You cannot switch the
◆
Check the battery pack (see page 19)
camcorder on.
or the AC power adapter. (see page 18)
Start/Stop does not
◆
Check the POWER set it to CAMERA.
operate while shooting.
◆
You have reached the end of the
cassette.
◆
Check the record protection tab on
the cassette. (see page 22)
The camcorder goes
◆
You have left the camcorder set to
off automatically.
STANDBY for more than 5 minutes
without using it.(see page 24)
◆
The battery pack is fully used up.
(see page 21)
The battery pack is
◆
The atmospheric temperature is
quickly exhausted.
too low. (see page 21)
◆
The battery pack has not been
charged fully.(see page 19)
◆
The battery pack is completely dead,
and cannot be recharged.
Use another battery pack.
You cannot eject
◆
The battery pack is fully discharged.
the cassette from
◆
A mechanical fault may have
the compartment.
occurred. (see page 57)
The DATE/TIME
◆
The lithium battery is not installed or
indicator flashes more
is fully used up. (see page 17)
than 2 times when you
set the camcorder to
CAMERA.
00606K VP-W80 UK+ESP(44-64) 3/20/03 8:36 AM Page 58