Sony Stereo Turntable System PS-LX300USB - Manual (Page 15)

1 GB
Additional I
nf
or
ma
tion
PS-LX300USB.GB.3-198-123-12(1)
To install the stylus
Do this procedure with the stylus protected by
the stylus cover.
1
Grasp both sides of the stylus holder, then
insert the stylus grip into the cartridge/
headshell receptacle.
Stylus holder
Stylus grip
Stylus cover
2
Push up the stylus holder until it clicks so
that it locks completely.
Do not leave any
space.
Note
Do not push the stylus cover forcefully. Otherwise,
the exposed stylus from the cover may cause injury, or
damage the stylus.
Troubleshooting
Before going through the check list below, first
make sure that:

The power cord is securely connected.

The speaker cords are securely connected.
Should any problem persist after you have made
these checks, consult your nearest Sony dealer.
Playing a vinyl record
The tone arm skips, skates or does not
advance.

The turntable is not level. Place the turntable
on a level surface.

The record is dirty or scratched.
Clean the record with a commercially
available record cleaning kit, or replace the
record.
Poor sound quality, excessive noise,
intermittent sound, etc…

The stylus is dirty or worn. Remove dust on
the stylus using a stylus cleaning brush, or
replace the worn stylus (see page 14).

Dust or dirt has collected on the vinyl record.
Clean the record using a good quality record
cleaner.
Continued
