Sony XCL-U1000 - Manual (Page 19)

19
Camera Control Command
DTL Setting Commands
■ Edge Enhancement Filter Coefficient Setting
[Command] DTL-COEF
[Parameter1] <K0 setting value (0 to 0x7F)>
[Parameter2] <K1 setting value (0 to 0x7F)>
[Parameter3] <K2 setting value (0 to 0x7F)>
[Process] Sets coefficients for the edge
enhancement filter. The currently set
value is applied to the parameter for
which no specific value is set.
■ Edge Enhancement Coring Threshold Setting
[Command] DTL-TH
[Parameter1] <Negative threshold (0 to 0xFF)>
[Parameter2] <Positive threshold (0 to 0xFF)>
[Process] Sets coring thresholds for the DSP edge
enhancement filter. When a value is set
only for Parameter1, the same value is
automatically applied to Parameter2.
■ Edge Enhancement Data Scale Setting
[Command] DTL-SCL
[Parameter1] <Negative enhancement level
(0 to 0x3F)>
[Parameter2] <Positive enhancement level
(0 to 0x3F)>
[Process] Sets enhancement levels for the DSP
edge enhancement filter. When a value
is set only for Parameter1, the same
value is automatically set for
Parameter2.
■ Edge Enhancement Data Level Setting
[Command] DTL-LVL
[Parameter1] <Lower limit of enhancement
(0 to 0x3FF)>
[Parameter2] <Upper limit of enhancement
(0 to 0x3FF)>
[Process] Sets enhancement limits for the DSP
edge enhancement filter. When a value
is set only for Parameter1, the same
value is automatically set for
Parameter2.
■ Sharpness Setting (For XCL-U1000C only)
[Command] SHARP
[Parameter1] <Sharpness (0 to 7)>
[Process] Adjusts sharpness of the output images.
■ DTL Mode Setting
[Command] DTL-MODE
[Parameter1] <Mode (0 to 1)>
0: OFF
t DTL OFF
1: ON
t DTL ON
[Process] Selects a DTL mode. When set to ON,
all the setting values set using DTL
Setting Commands becomes valid.
When set to OFF, values for the edge
enhancement data scale and the
sharpness are automatically set to “0.”
Color Setting Commands (For XCL-
U1000C only)
■ Color Matrix Setting
[Command] COLORMTX
[Parameter1] <Mode (0 to 2)>
0: OFF
t Invalidates RGB correction matrix.
1: ON
t Validates RGB correction matrix.
2: Data setting
t Sets matrix coefficients for Parameter1,
Parameter2 and Parameter3.
[Parameter2] <Matrix element (0 to 8)>
[Parameter3] <Matrix setting value (0 to 0x3FF)>
[Process] Sets coefficients for RGB conpensation
matrix. The values set in Parameter2 and
Parameter3 are ignored if “Parameter1: 2
(Data setting)” is not selected. The
mode setting value is retained only when
“0: OFF” and “1: ON” are selected.
Gamma Setting Commands
■ γ Table Setting
[Command] GAMMA
[Parameter1] <Mode (0 to 3)>
0: OFF
t γ=1
1: ON
t Validates the user setting table.
2: Reverse
t Reverse.
3: Binarization
t Binalize.
[Process] Sets
γ table.
■ γ Binalization Threshold Setting
[Command] BINARIZE
[Parameter1] <Binalization setting value
(0 to 1024)>
[Process] Sets a binalization threshold in
γ table. It
becomes valid only when “
γ table
setting: 3 (Binarization)” is selected.