Smarthome SUPERVISED WIRELESS SECURITY CONSOLE PS561 - Manual (Page 14)

POWERHORN REMOTE SIREN
SETTING UP THE POWERHORN
The POWERHORN Remote Powerline
siren responds to signals transmitted
by the Console (over house wiring).
When the alarm trips, the Console’s si-
ren sounds and lights flash. After the
lights have flashed on and off about 5
times, the POWERHORN trips. It
sounds for as long as the system is in
alarm and then shuts off about 10 sec-
onds after the alarm resets or is dis-
armed.
1.
2.
Set Housecode and Unit Code dials
on POWERHORN to same letter
and number as the Console.
Plug POWERHORN into a standard
AC outlet (not one controlled by a
wall switch).
WARNING: The POWERHORN is
extremely loud! Do not stand near it
when you trip the alarm. Prolonged
exposure to the 110 decibel output
could cause permanent hearing
damage.
Using the POWERHORN with
other X-10 Controllers
In a panic situation, you can trip the
POWERHORN from other types of
Controllers by either of the following
methods:
1.
2.
Press All Lights On followed by
All Units Off repetitively.
Press the number corresponding to
the Unit Code set on the POWER-
HORN, then press ON, OFF, ON
repetitively.
In both cases the POWERHORN will
trip after about 5 ON-OFF sequences
and will alter its tone for each ON and
OFF code. The siren will shut off
about 10 seconds after the last key
press.
14
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com