Smarthome SUPERVISED WIRELESS SECURITY CONSOLE PS561 - Manual (Page 16)

USING THE SYSTEM
CONSOLE
ZONE INDICATORS
The Console displays the status of the
first eight zones. These indicators can
display four states, as follows:
Steady on - means that particular
door or window is open.
Steady off - means that particular
door or window is closed.
Slow Flashing - means that particu-
lar Door/Window Sensor is reporting a
problem.
Fast Flashing - means that a particu-
lar Door/Window Sensor reported a
problem and the fault was bypassed,
or the door/window is open and has
been bypassed.
All Door/Window Sensors and Motion
Detectors report in to the Console
about every 90 minutes. If the Console
does not receive a signal from the sen-
sor within 4 hours, it reports a prob-
lem with that sensor by slowly flash-
ing the appropriate zone indicator. If
you try to arm the system while a zone
indicator is flashing, the Console
sounds a repetitive trouble alarm. Ei-
ther press [DISARM], correct the
problem and press [ARM] again, or
press [BYPASS] while the trouble
alarm is sounding, then press [ARM].
The zone(s) with a problem will not be
armed and the zone indicator(s) will
flash rapidly. AI1 other zones wilI arm.
If you bypass an open window and
arm the system, and later close the
window, that zone will now be armed.
ARMING AND DISARMING
THE SYSTEM
When you arm the system in the RUN
1 or RUN 2 mode, and open a door or
window, the following happens:
l A loud (95 decibel) siren sounds
for 4 minutes.
l Lights connected to Lamp Modules
and Wall Switch Modules (set to
the same Housecode as the Con-
sole) flash on and off.
l The automatic dialer dials the first
phone number stored and plays
back your message.
When armed, RUN 1 and RUN 2
modes are the same, opening a door or
window trips the alarm. When the sys-
tem is in RUN 2 mode and not armed,
the Console sounds a pleasant chime
when you open a door or window. In
RUN 1 there are no chimes.
Instant Mode
Note: The Key Chain Remote Control
(KF574) always arms the system in
the INSTANT mode.
1.
2.
If using the I-IT544 or SH624, set
its Delay switch to MIN.
Press [ARM]. The Console emits
two tones and the ARMED indica-
tor turns on.
Open a door or window, the alarm
instantly trips, the siren sounds,
lights connected to Lamp and Wall
Switch Modules
(set to the same
Housecode as the Console) flash on
and off, and the dialer dials out.
16
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com