Smarthome SUPERVISED WIRELESS SECURITY CONSOLE PS561 - Manual (Page 8)

SETTING UP DOOR/
WINDOW SENSOR(S)
This procedure initializes each Door/
Window Sensor so that the Console
recognizes signals from the sensor.
1.
2.
3.
4.
5.
6.
7.
Install a 9-volt alkaline battery in
the battery compartment.
Set the Console’s slide switch to
INSTALL.
Press [CODE] on the sensor with a
pencil.
Press [TEST). The Console’s next
unused zone indicator lights and
the Console sounds a tone to indi-
cate that it accepted the sensor.
Set the MIN/MAX switch to MIN
to protect a window. Set to Max to
protect a door.
Place one of the enclosed num-
bered stickers on the sensor to
show its zone number.
To set up additional sensors, (up to
16) repeat Steps l-6.
When you set the Console back to
RUN it plays back the stored message
and the BUSY Light stays on for 15
seconds.
Note: You can install any combination
of Door/Window Sensors (DW534)
and Motion Detectors (SP544) up to a
total of sixteen zones. For example:
you could install twelve DW534s , and
four SP544s, or any other combination
up to a total of sixteen zones.
DW534
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com