Woodstock SHOP FOX M1113 - Manual (Page 13)

-11-
Model M1113 (Mfg. Since 2/08)
SE
TU
P
•. Floor.Load: This machine distributes a
heavy load in a small footprint. Some
residential floors may require additional
bracing to support both machine, operator,
and material to be processed.
•. Working.Clearances: Consider existing and
anticipated needs, size of material to be
processed through the machine, and space
for auxiliary stands, work tables or other
machinery when establishing a location for
your bandsaw. Refer to Figure.4.
•. Lighting: Lighting should be bright enough
to eliminate shadow and prevent eye strain.
•. Electrical:.Place the machine near a
power source to avoid long runs of power
cords strung across your shop. Refer to the
Electrical section on Page.9 for information
on minimum circuit requirements.
Cleaning.Machine
The table and other unpainted parts of your
machine type are coated with a waxy grease
that protects them from corrosion during ship-
ment. Clean this grease off with a solvent clean-
er or citrus-based degreaser. DO NOT use chlo-
rine-based solvents such as brake parts cleaner
or acetone—if you happen to splash some onto a
painted surface, you will ruin the finish.
Machine.Placement
NEVER.clean.with.gasoline.
or. other. petroleum-
based.solvents..Most.have.
low. flash. points,. which.
make. them. extremely.
flammable.. A. risk. of.
explosion. and. burning.
exists. if. these. products.
are.used..Serious.personal.
injury. may. occur. if. this.
warning.is.ignored!
30-3/4"
40"
Figure.4..Model M1113 working clearances.