Woodstock SHOP FOX M1113 - Manual (Page 20)

-18-
Model M1113 (Mfg. Since 2/08)
SE
TU
P
Once the assembly is complete, test run the machine to
make sure it runs properly for regular operations.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety dis-
abling mechanism on the switch works correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review Troubleshooting on Page.46.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To.test.run.the.machine,.do.these.steps:
1. Connect the machine to the power source.
2. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is setup properly.
3. Ensure all tools and objects used during setup are
cleared away from the machine.
4. Press the green ON button on the power switch,
then press the ON key on the motor switch to start
the machine.
— When operating correctly, the machine runs
smoothly with little or vibration or rubbing noise.
— Investigate and correct strange noises or vibrations
before operating the machine further. Always dis-
connect the machine from power when investigat-
ing or correcting potential problems.
5. Turn the machine OFF.
6. Insert the switch disabling pin through the green ON
button, as shown in Figure.22.
7. Press the ON button to test the disabling feature on
the switch.
— If the machine does not start, the switch disabling
feature is working as designed.
— If the machine starts, immediately stop the
machine or disconnect the power. The switch dis-
abling feature is not working correctly. Call Tech
Support for help.
Test.Run
Figure.22. Switch disabling pin inserted
into ON button.
Projectiles. thrown. from. the. machine.
could. cause. serious. eye. injury.. Wear.
safety. glasses. to. reduce. the. risk. of.
injury.
DO.NOT.investigate.problems.or.adjust.
the.machine.while.it.is.running..Wait.
until. the. machine. is. turned. OFF,.
unplugged. and. all. working. parts.
have.come.to.a.complete.stop.before.
proceeding!
Switch
Disabling Pin