Woodstock SHOP FOX M1113 - Manual (Page 17)

-15-
Model M1113 (Mfg. Since 2/08)
SE
TU
P
Figure.13. Rear fence rail attached to
table.
Figure.15..Front fence rail attached.
10. Insert the rail bracket knobs through the front fence
rail brackets, then thread the T-nuts onto the ends
of the knobs a couple of turns.
11. Slide the front fence rail T-slot over the T-nuts, as
shown in Figure.15, then position the front fence
rail brackets even with the rear fence rail, and
tighten the knobs.
Figure.14. Rail brackets attached to table.
Rail
Brackets
9. Attach the rail brackets to the front of the table
with the two M6-1 x 16 cap screws, as shown in
Figure.14.
8. Attach the rear fence rail to the backside of the
bandsaw table with two M6-1 x 6 cap screws, as
shown in Figure.13.
Figure.16. Installing fence onto rails.
12. Pull the fence handle up and place the fence on the
front fence rail, as shown in Figure.16.
13. Slide the fence against the blade.
Rail Bracket Knobs