Sprint Nextel Sprint PCS Connection Card PC-5740 - Manual (Page 25)

Section 1C: Installing the Sprint PCS Connection Card 17
5. Select Sprint PCS Connection Card and click Next on the
“Select your card”screen.
6. Click Next to install the software to the default
destination folder (recommended). If you need to install
the software to a different folder, click Choose and select
an alternate installation destination.
7. Click Finish or Restart to complete the installation and
launch the Sprint PCS Connection Manager.
8. Wait for your PC to reboot.
Windows 2000: You may need to restart your PC
manually by selecting Start>Shutdown>Restart.
9. Click OK when you are prompted to insert the
Sprint PCS Connection Card. Insert the card into
the Type II PC Card slot.
Note: Do not forcefully insert the Sprint PCS Connection Card. This may
damage the connector pins.
10. Windows will detect the new hardware (Sprint PCS
Connection Card) and will install the necessary drivers.
The Add New Hardware Wizard or Found New Hardware
Wizard will launch, depending on your operating system.
11. Follow the onscreen prompts to allow the wizard to install
the drivers.
12. Click OK when you are notified that the installation
is complete.
On completion of this step, the Sprint PCS Connection Manager
Software and the Sprint PCS Connection Card driver are
installed and you can proceed to activate your card (if it has not
already been activated).
Installing Y
our
C
a
rd
Sprint_PC5740 (083105).qxd 9/23/2005 3:41 PM Page 17