SMSC USB464 - Manual (Page 20)

High Speed Inter-Chip USB 2.0 Hub and Flash Media Controller
Datasheet
Revision 1.0 (06-01-09) 20 SMSC USB4640/USB4640i
DATASHEET
GPIO2 /
RXD
36 I/O6 This pin may be used either as input, edge sensitive interrupt input,
or output. Custom firmware is required to activate this function.
This signal can be configured as input to the RXD of the internal
UART. Custom firmware is required to activate this function.
GPIO10
(CRD_PWR)
35 I/O200 Card power drive: 3.3 V (100 mA or 200 mA)
This must be the only FET used to power devices. Failure to do this
will violate voltage specifications on device pins. If this pin is not
being used as a card power pin, this pin may be used either as input,
edge sensitive interrupt input, or output (GPIO).
Please see Section 8.4.2.3, "A4h-A5h: Smart Media Device Power
Configuration," on page 38 for more information.
nRESET 38 IS RESET input
The system uses this active low signal to reset the chip. The active
low pulse should be at least 1 μs wide.
TEST 40 I TEST Input
Tie this pin to ground for normal operation.
DIGITAL / POWER / GROUND
CRFILT 15 VDD Core Regulator Filter Capacitor
This pin requires a 1.0 μF (or greater) ± 20% (ESR <0.1 Ω ) capacitor
to VSS.
PLLFILT 46 Phase-locked Loop Regulator Filter Capacitor
This pin requires a 1.0 μF (or greater) ± 20% (ESR <0.1 Ω ) capacitor
to VSS.
VDD12 41 1.2 V Power for HSIC pads and buffers
VDD33 5
12
16
25
34
48
3.3 V Power and Regulator Input
Please see Chapter 10, "DC Parameters," on page 56 for more
information.
Pins 16 and 48 each require an external bypass capacitor of 4.7 μF
minimum.
VSS ePad The ground pad is the only VSS for the device and must be tied to
ground with multiple vias.
Table 6.1 USB4640/USB4640i Pin Descriptions (continued)
SYMBOL
48-PIN
QFN
BUFFER
TYPE
( Table 6.2 ) DESCRIPTION